Magnetic Finishing Part-Condition Fit: Condition, Suitability and What Must Be Validated
This page reproduces the part-condition fit table for magnetic finishing: the condition, how it fits magnetic finishing, and what must be validated before you rely on it. The wording is deliberately cautious: a good trial candidate is a starting position to verify, not a result. The table comes from a Jintaijin product page and is a part-condition guide, not a machine specification or a performance claim for any model.
Browse the published rows
Choose a section or search the published rows, then read the article text.
Part condition, fit for magnetic finishing and what must be validated
| part condition | fit for magnetic finishing | what must be validated |
|---|---|---|
| Small stainless or non-ferrous parts with light burrs | Good trial candidate | Burr location, edge change, pin access, cleanliness |
| Parts with holes, slots, recesses, or threads | Potential advantage | Retained pins, thread fit, trapped liquid, feature damage |
| Fragile, thin, or easily tangled parts | Conditional | Part-to-part contact, deformation, tangling, batch concentration |
| Large parts or heavy casting flash | Usually poor fit | Alternative deburring and finishing process |
| Parts requiring certified surface or dimensional results | Trial plus documented inspection | Drawing requirements, gauges, cleanliness and downstream validation |
About the source of this table
The table is reproduced from a Jintaijin product page. It is a part-condition fit guide, not a machine specification and not a performance claim for any model.
Source and its limits
Published reference page; captured 5 October 2026. SHA256: c1d01ff2cf03875b20b32e333a6038ce109961acc507560af4519bcf082cc8ba.
- Suitability wording and validation points are the published page own, reproduced verbatim. They describe part conditions, not a machine specification.
- No throughput, cycle time, speed, media specification or result is stated, implied or supplied.
- A fit wording such as good trial candidate is a starting position to verify, not a validated result.
Table headers as published
- Part condition / Fit for magnetic finishing / What must be validated
Frequently asked questions
Does "good trial candidate" mean it will work?
No. It is a starting position to verify on a sample, not a result and not a guarantee. The column that matters is what must be validated.
Is this a specification for a magnetic finishing machine?
No. It is a part-condition fit guide taken from a product page. It states no throughput, cycle time, speed or media specification.
Does it diagnose my part?
No. A symptom lists a likely cause and a first check. The same visible mark can have more than one cause, and confirming it needs a controlled test on a sample.
Does it state cycle time, speed or temperature?
No. No cycle time, speed, amplitude, load ratio, concentration, temperature or removal result is stated or implied anywhere on this page or in its download.
Are the tables quoted exactly?
Yes. Every cell is taken from a single source table cell and verified against the captured page, including wording and punctuation.
+86-592-2381506 
IPv6 network supported 